Multi Metallographic Mount Holder, 1" and 25mm PeakForce QNM 25 Cantilever Geometry: Rectangular Back

25 Cantilever Geometry: Rectangular Back Side Coating: Reflective Aluminum

force modulation mode

flat angled tips 62A 115mm NM-SS 02

Width x Thickness 5226 DUMONT Electronic

including 10 etched silicon probes (Model MESP)

Multi Metallographic Mount Holder, 1" and 25mm PeakForce QNM 25 Cantilever Geometry: Rectangular BackDESCRIPTION Multi Metallographic Mount Holder, 1" and 25mmSpecimen holder for 4 x 1" and 25mm metallographic mounts. Holder height is 0. 41" (10. 4mm), with recessed areas 0. 31" (7. 9mm) deep. Open sides for easier sample removal. Material: machined aluminum with stainless steel allen screws. Allen wrench included. Shown holding one metallographic mount (not included). Screws used are M3 x 6mm Soc Cap, SS and M3 x 12mm Soc Cap, SS