Sloping Cross (0-11 degrees) for 48mm Galvanised Pipe Treated Baluster Type 155 may often be

Type 155 may often be used as an alternative

This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 42mm

often used to make additions or alterations to existing structures where a type 161 cannot be fitted

The ridge tube running longitudinally with the roof may be joined within the fitting (there are two setscrews acting on this tube

The 140 Gate Hinge Pin is often used with type 138 to form gate hinges

Sloping Cross (0-11 degrees) for 48mm Galvanised Pipe Treated Baluster Type 155 may often beWhere would you normally use this galvanised pipe fitting? The 156 Slope Cross (Middle Rail) is adjustable for slopes from 0 degree to 11 degree, and normally used between middle rail and uprights on sloping sites and often paired with type 153 or 155. The through tube (vertical in photo) cannot be joined within the fitting. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 48mm.