Verandah Bracket No.1 355x355x32mm Fretwork Solar Panel Supports

Solar Panel Supports

Plantation-grown

Plantation grown finger jointed Radiata Pine that has been H3 treated (suitable for above ground use)

The 117 fittings are a retro-fit type fitting designed to be added on to existing structures without the need to dissassemble The 117Y fitting comes complete with 4 socket pieces and 3 plate pieces which enable each kit to be used to make one of the three possible assemblies illustrated below

and/or where there is a requirement for rails to be offset from uprights

Verandah Bracket No.1 355x355x32mm Fretwork Solar Panel SupportsWhere would you normally use a treated timber verandah bracket ? As a decorative corner piece (between a post and facia board), used perhaps on a verandah or pergola. It is supplied as 2 pieces that when attached to the post and facia will form the bracket that you see in the photo. What is it made out of ? Plantation grown Radiata Pine that has been H3 treated (suitable for above ground use). How should you finish it ? A water based primer undercoat