Triumph Pre Unit 4-Spring Clutch Pressure Plate KIT 650 750 Triumph Exhaust stronger than grade-8)

stronger than grade-8)

Suitable to replace the LEFT handlebar switch and clutch lever of Meriden Triumph models 1979-on

(Versions without eyelets available in another listing

long enough for the largest handlebars imaginable

this part (0420-49-120) is the crankcase vent spigot used on just about ALL Ducati singles

Triumph Pre Unit 4-Spring Clutch Pressure Plate KIT 650 750 Triumph Exhaust stronger than grade-8)Suitable for the 4 spring clutch used on pre unit Triumph with 12. 25" pushrod (T1552). Unlike other kits on the market, new modified clutch pushrod is INCLUDED. Everything should bolt on with no mods, unless your trans has the shorter T1551 pushrod. Needle bearing center, aluminum billet pressure plate, shortened clutch pushrod case hardened through it's ENTIRE length. Excellent stuff!